Silvia Club of NSW
https://silviansw.com/forum/

boost pressure via wastegate actuator
https://silviansw.com/forum/viewtopic.php?f=4&t=7009		 Page 1 of 1
Author:  ika [ Mon Feb 09, 2004 7:45 pm ]
Post subject:  boost pressure via wastegate actuator
Was wondering if in SR20 Turbo is the boost pressure adjustable via the wastegate actuator. If so how?
Cheers
Author:  cypher1024 [ Mon Feb 09, 2004 8:10 pm ]
Post subject: 
You can lengthen/shorten the wastegate actuator arm... but that's a little difficult... Alternately, you could install a bleed valve or boost controller.... (zei can help you with this ;))
Author:  RPS13X [ Tue Feb 10, 2004 8:09 am ]
Post subject: 
you can also get HKS actuators to fit a variety of turbos. They are around 200-250 mark.

I dont know if you can get them on with out having to pull of the turbo, but if you can it would be a much more sound way o getting more boost.

i think they set it to around a solid 12psi.
Author:  ZEi250t [ Tue Feb 10, 2004 10:03 am ]
Post subject: 
its a more reliable way of getting more boost, but then - if you want it - you dont have a way of getting two boost settings unless you go higher than the wastegate is set at. eg wastegate 12psi, high boost at 15 - via a bleede valve or some sort of boost controller.
Author:  Boosted_200 [ Tue Feb 10, 2004 2:50 pm ]
Post subject:  Re: boost pressure via wastegate actuator
ika wrote:
Was wondering if in SR20 Turbo is the boost pressure adjustable via the wastegate actuator. If so how?
Cheers


You will have to make the wastegate rod adjustable by modifying it suitably so when you turn it in the direction of the thread it shortens and the other way lengthens, turning the boost up and down respectively, not too what it needs exactly to do this though.
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/