Silvia Club of NSW https://silviansw.com/forum/ |
|
Engine swap https://silviansw.com/forum/viewtopic.php?f=4&t=8487 |
Page 2 of 2 |
Author: | fatz [ Mon May 03, 2004 10:45 am ] |
Post subject: | |
crossmembers are the same the engine monts bolt straight in pete but you will probably need new engine mounts as they brake after a few years |
Author: | cypher1024 [ Tue May 04, 2004 12:07 am ] |
Post subject: | |
So all you need is the new engine, ecu, loom, g/box and frontpipe? |
Author: | fatz [ Tue May 04, 2004 10:55 am ] |
Post subject: | |
yup the engine mounts are even the same so if you get the sr20 with broken mounts you can use the ones of your ca you will need a new clutch master cylinder cause the ca doesnt fit behind the sr motor |
Author: | cypher1024 [ Tue May 04, 2004 9:20 pm ] |
Post subject: | |
Cool. So maybe a 1/2 cut would be in order? |
Author: | sxin' [ Wed May 05, 2004 8:25 pm ] |
Post subject: | |
i just did one of these youll need the motor, gearbox, engine loom and ecu and clutch master cyl. The rest is all the same, even the tailshaft will go back in the same way. The other things that will need slight alteration are the cooler pipes and the dump pipe. Also new brakes are a must. |
Author: | cypher1024 [ Wed May 05, 2004 11:21 pm ] |
Post subject: | |
:D And maybe a tailshaft if one has an auto.... |
Page 2 of 2 | All times are UTC + 10 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |