Silvia Club of NSW

wat happens if u put the bleed valve in the wrong way.. eg the arrow pointing in the wrong direction??? coz my cars not running anything ova stock boost even after i turned it up??
does it stuff up ur turbo??

I would of said if ur run the arrow the wrong way u get unlimited boost until turbo explodes or somethihng like that? Cause it wouldnt let pressure through the line? Dunno for sure but if ur still running standard it would most likely mean you have installed it in the wrong place, i.e the facotry solenoid is working around it. I would turn the valve back to lowest and put the tpiece in between the possitive pressure line (sr20's it comes from cooler piping at front of engine bay, ca18 its the hose on the compressor housing above the intake pipe) so the new tpiece goes between positive pressure line and the old tpiece that goes to actuator and solenoid this way it will bleed around the factory solenoid or so i have heard. I hope this is right if anyone else can comment? white180sx will know cause he has bleed valve actually a post similar can be found here http://www.silviansw.com/forum/viewtopic.php?t=2476
where white180sx tells how to install bleed valve. DDont read anything i wrote cause its to do with electronic boost controller, but white180 talks of a bleed valve

Hope this huge text helps :p and this pic

if its sr20 it will look something like this
if you want an actual picture i can get one but this should be sufficient
anyone else can tell me im wrong if i am cause i dont wanna be blamed but pretty sure this is right

_________________
To be old and wise you must first be young and stupid.
If we aren't supposed to eat animals why are they made of meat?

thanx... it was pointing the wrong direction i found out...
switched it back and it boosts up fine now